plasma gas

英 [ˈplæzmə ɡæs] 美 [ˈplæzmə ɡæs]

网络  等离子气体; 等离子体气; 等离子气流量; 等离子气; 等离子体工作气

化学



双语例句

  1. Rapid Determination of DDVP in Human Plasma by Gas Chromatography
    气相色谱法快速测定人血浆中敌敌畏浓度
  2. Plasma gas chromatography Determination of Trace Phthalate Esters in Plastic by GC/ MS with Ion Trap
    气相-离子阱串联质谱技术对塑料中痕量邻苯二甲酸酯的检测
  3. Fast detection of four pyrazines in Chinese liquor by GC-MS/ SIM plasma gas chromatography
    气相色谱-质谱-离子扫描联用法快速检测白酒中4种吡嗪类化合物
  4. In addition, it may utilize more plasma gas inlets ( 76).
    此外,它还可以利用更多的等离子气体进口(76)。
  5. The plasma gas will become toxic within minutes.
    等离子气体会几分钟内达到有毒浓度。
  6. In the present study, tungsten oxide nanorods were prepared by a plasma arc gas condensation technique where a gas nozzle was introduced to provide blowing gas.
    本研究以电浆电弧为加热源蒸发钨靶材,并藉由气凝合成机制,外加一套吹气装置制备氧化钨奈米棒,分别探讨腔体压力与奈米棒平均直径及产率的关系。
  7. Plasma gas chromatography Multiresidue Determination of Triazine Herbicides and Some Metabolites in Maize by GC-CI MS/ MS
    气相色谱化学电离二级质谱法对玉米籽粒中三嗪类除草剂及其代谢物的测定
  8. Nanometer iron powder was prepared by utilizing modified the circulating water and plasma gas.
    采用循环水冷却和循环等离子体工作气体的改进方法,制备出纳米铁粉。
  9. Preliminary Study on Thermal Plasma Flue Gas Desulphurization
    热等离子体烟气脱硫技术初步试验研究
  10. The welding current, welding speed and the plasma gas flow rate were the most important parameters in the ending stage.
    发现焊接电流、离子气流量和焊接速度对收弧过程影响较大。
  11. Corresponding with different displacements of simulated diesel engine, the optimal quantity of non-thermal plasma gas injection exists, which will lead to the maximum conversion rate of NO.
    对应于不同的柴油机排气量,低温等离子体气体喷射量存在一个最佳值,可使得NO转化为NO2的效率最高;
  12. By any of the above mentioned methods, a characteristic emission spectra can be obtained for the plasma gas and each substance in it.
    通过前面的任何一种方式,可得到等离子气体和其它组分的特征发射光谱。通过特征光谱判定每种物质。
  13. Also, the dependence of the nozzle diameters and the mass flow rate of plasma gas on plasma power and arc force has been discussed.
    同时讨论了空气流速及喷嘴直径对等离子体功率及作用力的影响。
  14. However, the decrease as well as the aggregation of SiC particles can be somewhat restricted as argon-nitrogen mixture rather than pure argon has been employed as plasma gas.
    采用氩-氮混合气体代替纯氩气作为焊接的离子气,SiC颗粒烧损和团聚可在一定程度上得到抑制。
  15. The effects of the plasma power, spraying distance and plasma gas flow rate on the microstructure and properties of the coatings were investigated.
    研究了电弧功率、喷涂距离和等离子气体流量对涂层显微组织和性能的影响。
  16. In this work a CSTR model was adopted to simulate the chemical reaction processes in non-thermal plasma flue gas denitrification.
    本文采用CSTR模型,对非热等离子体烟气脱硝的化学反应过程进行数学模拟。
  17. Experimental results showed that it is an effective N doping way for SiC films by injection of N 2 as plasma gas, however, it also has significant influence on the morphology, composition and deposition rate.
    实验结果表明:向等离子体中导入N2是对SiC膜进行掺杂的有效方法,但同时也显著影响SiC膜的形貌、成分和沉积速度。
  18. The variation of the plasma gas flow can heavily influence the fluidity of the puddle metal and the weld formation though the diameter of the keyhole is hardly changed.
    虽然离子气流量的变化对穿孔熔池的孔径影响较小,但对熔池金属的流动性和焊缝成形影响较大。
  19. This paper introduces the design of AC superposed DC power supply used for corona plasma flue gas desulfurization.
    介绍了新型等离子体烟气脱硫交直流叠加电源的设计。
  20. The results show that interfacial reaction between SiC and matrix aluminum can be weakened greatly while titanium is used as alloying filler, N2+ Ar is used as the plasma gas synchronously.
    结果表明:以Ti为合金化填充材料,以N2+Ar为离子气,可以大大减弱SiC颗粒与基体Al之间的界面反应。
  21. Effects of SO_2, NH_3 and temperature on non-thermal plasma flue gas denitrification
    非热等离子体烟气脱硝中的二氧化硫、氨和温度的效应
  22. Also, the influence of nozzle diameters, tungsten setback and plasma gas flow rate on the arc power and force of the welding plasma with the respective currents was analyzed, and curves are drawed.
    同时还分析了喷嘴直径、钨极内缩量以及离子气流速在相应的焊接电流下对等离子弧功率与电弧力的影响,并绘出曲线图。
  23. Plasma arc welding of SiC_p/ 6061 composite has been studied as argon or argon-nitrogen mixture has been employed as plasma gas.
    分别采用纯氩和氩-氮混合气作为离子气,对SiCp/6061复合材料进行了等离子弧焊研究。
  24. Results: The level of plasma GAS, MTL, VIP and SS in MODS patients decreased significantly, then increased gradually following with the lightening of MODS 'state.
    结果:腹部外科术后MODS患者血液中胃肠道激素水平明显降低,随着MODS病情的减轻,血液中胃肠激素水平逐渐上升。
  25. Oxygen was selected as the In-situ plasma stripping gas after gases resource optimization.
    通过气源优化比较,选择氧气作为原位等离子体去胶的气体。
  26. The plasma Gas 6 levels were correlated with cerebral infarction, cerebral hemorrhage, and acute myocardial infarction. 2.
    结论:1.血浆Gas6水平与脑梗死、脑出血和AMI相关。
  27. Recently a small amount of literature at home and abroad has been reported that the plasma Gas 6 levels and gene polymorphism is related to cardiac-cerebral thrombosis disease, but results vary.
    最近国内外有少量的文献报道,血浆Gas6水平及其基因多态性与心脑血栓的患病风险相关,但研究结果不一。
  28. This research aims at developing a novel streamer plasma flue gas desulfurization technological process by use of a gas discharge plasma and chemical method.
    本论文研究目标是采用气体放电等离子体和化学的方法,开发一种流光放电等离子体氨法烟气脱硫的新工艺。
  29. Describe the basic process of gas discharge, the basic nature and characteristics of discharged plasma gas, glow discharge characteristics and some parameters of the calculation. 3.
    2概述气体放电的基本过程、气体放电等离子体的基本性质和辉光放电特性及一些参数的计算。